Eventuri carbon intake system for Audi S3 8Y 2020+ and TTS 2022+Performance increase (series Golf R): 10-13hp, 12-15NmPerformance increase (tuned Golf R): 15-20hp, 25-30NmSuitable for: S3 8Y 2020+ and TTS 2022+ The S3 8Y intake manifold is a complete redesign of the stock intake manifold right up to the turbo inlet. Taking inspiration from our RS3 intake tract, we have made the most of the available space to create an intake tract that is suitable for all power levels, from stock equipment to high performance systems with hybrid or full frame turbos. This intake system is designed to provide the highest possible flow rate while achieving the lowest intake temperatures. Every component has been designed to give the turbo a smooth and unobstructed flow path. The restrictive stock 73mm diameter intake pipe is replaced with a larger diameter 94mm intake pipe. The filter itself has an outside diameter of 192mm or 7.5? with a filtering area of ​​over 110,000mm^2. The patented venturi housing is designed to provide the largest possible internal volume for the available space in the Golf engine bay and provides laminar flow to the turbo pipe. Finally, the duct seals the filter opening at the front screen but is not restricted by the stock feed alone. We have raised the front of the duct to now create an additional opening behind the bonnet, which corresponds to an additional 7? diameter hole for the intake to draw from. The resulting system can significantly outflow the stock airbox whilst keeping intake temperatures to a minimum with the sealed design.Dyno TestingOur MK8 Golf intake has been independently tested by a reputable tuner in the UK, Regal Autosport. Testing was carried out on a MK8 Golf R in its original condition and with a tuning box. Testing was carried out on the same day, with the stock airbox tested first and then the Eventuri. No other changes were made to the car. The first graph shows the results using a stock map. As can be seen, there is a measurable gain across the rev range up to 12bhp. This gain is noticeable even on a stock car on the road with better throttle response and quicker acceleration. The second graph shows the results when using a tuning box which increases the flow requirements of the intake system. The tuning box was used on both the stock airbox and the Eventuri intake with no changes made between tests. With a higher flow requirement, the stock airbox places a greater restriction on the turbo, which is evident by the significant gain achieved with the Eventuri fitted. We now have up to 20hp and 30Nm of power gain across the entire rev range, which is even more noticeable on the road. We expect the gains to be even greater with higher tune levels.The improvements are due to a combination of reasons:1) The closed system keeps IAT levels low - the Golf's engine bay can heat up very quickly, so an open cone filter will cause IAT levels to rise and therefore power to be lost.2) The Venturi housing provides a smooth transition from the filter to the intake pipes, both of which are tuned to a 94mm internal diameter. This helps the turbo run more efficiently.3) The entire system is made from pure pre-impregnated carbon fiber, which provides excellent heat insulation and has smooth internal surfaces, unlike fiberglass which has sharp resin lines.